As a recurve archer, your sight is a vital piece of your equipment. Recently, I had a request to do a blog about the anatomy of a sight and how to adjust it. Although every sight is different, they all have similar components. We will use the Cartel Mighty sight in this example.
A recurve sight is typically made of four components; the riser mount with knob, horizontal extension bar, vertical sight bar, and scope. The riser mount is used to attach the sight to the riser and the knob is used to hold one end of the horizontal extension bar. The vertical sight bar is mounted to the other end of horizontal extension bar with the scope attached to it. The vertical sight bar and scope have thumb screws that are used to adjust and micro-adjust the scope in relationship to the target.
Most sights have three knobs, one to adjust the length of the horizontal extension bar, one to adjust the height of the scope and one to adjust the left/right location of scope. The latter two usually have both large and micro-adjustments available. When you are ready to start adjusting your sight, remember the simple rule, “Follow the arrow”. Check out my earlier blog called Follow the Arrow: Adjust your sights.
To adjust the length of the horizontal extension bar simply loosen the knob and extend it to the desired length and tighten the knob to secure it. The marks on the bar to help you remember the length so you can set it up again.
To make an adjustment of the vertical location of the scope, loosen the thumb screw fastener and either depress the thumb lever for a large move or turn the micro-knob for small adjustment. Once complete then tighten the thumb screw fastener to secure it.
To make a left or right adjustment of the scope, loosen the thumb screw fastener and either twist the scope in or out for a large change, or twist the tension knob for micro-adjustments and then tighten the thumb screw fastener to secure it.
Once you have adjusted your sight make sure to shoot several arrows to confirm your adjustments. Once you are satisfied with the results, record the location of the sight marks on the vertical sight bar. Remember as you grow, develop muscle and change equipment your sight marks will move. One trick is to add a thin piece of white tape over the sight marks. This allows you to adjust the markings without permanently damaging the sight itself.
Jordan Sequillion 
Thanks for the anatomy post! My Cartel X-pert sight has a knob that allows the scope to move up or down in an angle, what’s the purpose of this? Also, when I move my scope left or right, it doesn’t look like it’s moving at all. I take this is normal?
Reblogged this on My archery experiences and commented:
Worth checking out if you use sights on your bow. Great blog too.
Pingback: Bow Tuning – Advanced Tuning | Jordan Sequillion
Excelente post ! My new sight, a Shybuia Ultima RC arrived yesterday, tomorrow I will use it with my bow.
Pingback: Adjusting to a Recurve Sight | archery parent