Adjusting your sights

As a recurve archer, your sight is a vital piece of your equipment. Recently, I had a request to do a blog about the anatomy of a sight and how to adjust it. Although every sight is different, they all have similar components. We will use the Cartel Mighty sight in this example.

A recurve sight is typically made of four components; the riser mount with knob, horizontal extension bar, vertical sight bar, and scope. The riser mount is used to attach the sight to the riser and the knob is used to hold one end of the horizontal extension bar. The vertical sight bar is mounted to the other end of horizontal extension bar with the scope attached to it.  The vertical sight bar and scope have thumb screws that are used to adjust and micro-adjust the scope in relationship to the target.

Most sights have three knobs, one to adjust the length of the horizontal extension bar, one to adjust the height of the scope and one to adjust the left/right location of scope. The latter two usually have both large and micro-adjustments available. When you are ready to start adjusting your sight, remember the simple rule, “Follow the arrow”. Check out my earlier blog called Follow the Arrow: Adjust your sights.

To adjust the length of the horizontal extension bar simply loosen the knob and extend it to the desired length and tighten the knob to secure it. The marks on the bar to help you remember the length so you can set it up again.

To make an adjustment of the vertical location of the scope, loosen the thumb screw fastener and either depress the thumb lever for a large move or turn the micro-knob for small adjustment. Once complete then tighten the thumb screw fastener to secure it.

To make a left or right adjustment of the scope, loosen the thumb screw fastener and either twist the scope in or out for a large change, or twist the tension knob for micro-adjustments and then tighten the thumb screw fastener to secure it.

Once you have adjusted your sight make sure to shoot several arrows to confirm your adjustments. Once you are satisfied with the results, record the location of the sight marks on the vertical sight bar. Remember as you grow, develop muscle and change equipment your sight marks will move. One trick is to add a thin piece of white tape over the sight marks. This allows you to adjust the markings without permanently damaging the sight itself.

Advertisements

Getting more Distance

Summer is here and with it the outdoor archery season. One of the biggest differences between indoor and outdoor archery, other than weather, is distance to the target.

Indoors everyone typically shoots at 18M however outdoors, depending on your age, division and category, you can shoot anywhere from 15M (Peewee) to 90M (Senior Male). As young archers get older and move up in division so do the distances they are asked to shoot. For instance, a pre-cub only needs to shoot maximum 30M in a target competition, however as a cub they need to shoot 50M. I remember trying to shoot Junior/Senior distances as a Cadet; 70 meters was a challenge. My sight was at the bottom and I was still not getting the distance I needed.

If you are struggling with a new distance you can make some equipment changes that can help such as ….

  • Heavier Limbs

Increasing draw weight will give you more force and therefore greater distance.

  • Move the entire sight down

Some sights, like the Cartel Mighty sight, you can move the entire T-bar lower. This allows you to lower the scope. Just remember to keep it out of the arrows flight.

  • Finger tab with a Shelf

Some finger tabs, like the Cartel Midas Finger Tab, have a shelf. If you adjust the shelf to be fully extended, you can lower your anchor point.

  • Spin vanes

For target archers you use synthetic feather fletchings, switching to plastic spin-wing vanes manufactured by Range-O-Matic can help a lot. Spin-wing vanes are lighter, offer less drag and are more forgiving as they help the arrows get into a tighter spin earlier.

Some times equipment changes are not an option because of cost, physical limitations and some times they only get you part way. Here are a couple of simple tricks that may help you reach those last couple of meters.

  • Wear a Mouth-Guard

Using a mouth-guard (or a piece Lego between your teeth) keeps your jaw open lowering your anchor point.

  • Mount your Sight Backwards

Mounting your sight backwards inside your bow, moves your sight marks lower and therefore changes the trajectory.

  • Use your Limbs as a Sight

In clout, a long distance (100M to 200M) sport you use your bottom limb as the sight. This can work for target archery as well. Pick a spot near the top of your lower limb to aim with for your possible distance.

If you have any tricks or tips to help gain more distance, I encourage you to share them.