Bow Tuning – Advanced Tuning

So far in this series, we started by discussing the basic Olympic recurve bow setup. We covered what tools you require for bow tuning and to basically setup your bow. This included limb alignment, how to measure, installing the arrow rest, nocking point and setting up your basic center shot.

Now that your bow is basically setup, you have been practicing with it and have a fairly consistent arrow group it is time to do some advanced tuning of your bow. Remember that basic step-up and tuning can be done quickly to get you started however advanced tuning is a time consuming task through trial and error.  Proper shooting technique is always the first thing every archer should focus on. If you are still struggling with the basics then get your bow basically setup and work on consistency.  To avoid massive amounts of frustration, it is very important to focus on changing and tuning one thing at a time. Read my earlier blog about Consistency and Change.

Next we will focus on individual areas for you to tune such as nocking points, bowstring fit, centering, clearance, brace height, sight alignment, tiller, clicker and plunger adjustment. Since I already created several blogs about tuning specific components your bow, you should start by reviewing the following…

Sight : Following the arrow and adjusting your sights

Clicker : Adjusting and shooting with a Clicker.

Arrows and various tuning methods : Arrow Series – Part 8 – Fine Tuning and Numbering

Remember, bow tuning is an advanced technique and if you can I recommend you employ the knowledge and experience of a trained coach, since another pair of eyes can really help make the difference between a good tuning and perfection. In the next part of the series we will continue and take a deeper dive into the remaining areas of your bow that can be tuned. 

Bow Tuning – A Simplified Series for Beginners

Your bow is  very personal to you and should be tuned specifically to you and your shooting style. Since there are tons of in-depth, technical articles about bow tuning produced by many organizations and manufacturers, my goal is to simplify the concepts for beginner archers. Although, my primarily focus will be an Olympic recurve bow, some or most, if not all, the principals can be applied to other disciplines.

In this series we will discuss, but not limit to, nocking points, bowstring fit, centering, clearance, brace height, sight alignment, tiller, clicker, plunger adjustment and discuss various tuning methods. Remember that basic step-up and tuning can be done quickly to get you started however advanced tuning is a time consuming task through trial and error.  Proper shooting technique is the first thing every archer should focus on. If you are still struggling with the basics then get your bow basically setup and work on consistency. From there, a well tuned bow can help compensate for personal idiosyncrasies and help you achieve the maximum performance.

So, in preparation for this series, review and ensure you have the correct equipment for you. You need to have equipment you can use. If the bow is too small or light, or alternatively too heavy, in-depth tuning is not going to provide many advantages. Alternatively, if your equipment is just above or below were you need to be; advanced tuning can help rein a bow in. Also, make sure you have selected the correct arrows for your setup. Review my Arrow Series about arrow selection to make sure you have selected arrows that are best for you.

Always remember that there are several steps to properly tune your bow for maximum performance. You should record every adjustment so you are able to retrace your steps should an adjustment provide negative results. Remember to adjust only one thing at a time and then test. Remember that even one piece of new equipment will require bow tuning and the amount will depend on the importance of that piece. For example, a new plunger a little bit of tuning and new limbs with higher poundage means you may be starting from square one.

Bow tuning is an advanced technique and should be only attempted by archers with at least a good understanding the bow mechanics. I recommend you employ the knowledge and experience of a trained coach. I still work with my coach to tune any new bow that I receive, since a second or third pair of eyes can really help make the difference between a good tuning and perfection.