Rests

Basically an arrow rest is part of your bow setup that holds the arrow in place, ready to be shot. Allen asked…

What kind of rest would you recommend for a beginner recurve shooter? I’m a COMPLETE newbie to archery, so I blindly went with the archery shop guy’s recommendations when buying my first bow. I ended up buying a Samick Polaris that he set up with a rug rest. Is this a bad kind of rest to use? Wouldn’t the two non-index fletches hit the bow on the way out? My arrows tend to hit the target at an angle instead of perpendicular, so I wonder if the rest could be causing it.

First lets cover the various types, most people say there are four basic types of arrows however I believe there are five; shoot-thru, containment, drop-away, pressure/plunger rests and the additional shelf. The shelf is often overlooked because it is part of the bow, however you do “rest” the arrow on it.

Here is a general overview of each type.

Shoot-thru (or prong) rest : A two-pronged arrow rest with a gap between and spaced about two-thirds of the width of the arrow to create a cradle. The arrow sits on top of the prongs with one fletching pointing down between them and is usually spring-loaded to allow additional clearance for the fletchings. These rests can be tricky for beginners because the arrow can fall off with wind or bad form.  They are best for hunting and the use of a mechanical release.

Containment rest : A totally encircled or a simultaneous 3-point contact arrow rest holding the arrow completely in place until release. These are the most common choice for archery hunting, they are relatively easy to install and tune. Great for beginner hunters since the arrow will not fall off the rest.

Drop-away (or fall-away) rest : Designed to drop out of the way upon release and therefore eliminate any chance of contact with the arrow. Activated by the release of the string, the rest holds the arrow long enough to keep straight and needs to drop out of the way before the fletching reaches the rest. Since this can be very tricky to tune; it is best suited for a compound bow. It is popular for hunting with large fixed-blade broad heads and helical fletchings.

Pressure/Plunger rest: Used commonly by finger shooters (no-mechanical release), they are designed to counter-act the horizontal oscillation from release with your fingers. Standard type bows without a cut-away, typically use a simple flipper rest (a rest with an additional “flipper” that acts like a plunger to help push-back against the pressure). Bows designed with a cut-away for your center shot typically use a rest along with an adjustable plunger. A pressure rest is used on Olympic bows and can be used be any finger shooter.

Shelf: Most traditional longbows and modern recurves bows are now designed with a cut-away area in the riser which includes a shelf area. For this type of bow instead of a pressure rest you can choose to shoot off the shelf. An arrow rest is attached to the shelf of your bow and is usually installed with an arrow plate to the side. They serve as protection for the bow and arrow and act as a soft, smooth surface for the arrow to be shot from.

Selecting a rest depends on a list of things including…

  • Type of bow (compound or recurve)
  • Chosen application (hunting or target shooting),
  • Type of release (finger or mechanical)
  • Budget (cold hard cash)
  • Experience (your ability to tune the rest and bow)
  • Form (some rests are more forgiving)
  • Tradition and historical nostalgia
  • Competition division (division restrictions)
  • And personal preference (bling factor)

There are a ton of rests available on the market and most bow manufacturers follow the same AMO (Archery Manufacturers Organization) standards. Therefore the drilling and tapping for the majority of bows are universal however before you purchase or upgrade make sure a selected rest will work and function with your bow.

A rug rest is a type of rest for a shelf and could be a very good selection for your shooting style if you are shooting traditional however it would not be the best selection for an Olympic archer or a compound hunter.  I am not in a position to recommend the best rest for your bow, since the bow is only as good as the alignment between the rest, release and nocking point. Obliviously, a better quality rest for your style of shooting can impact your accuracy.

To specifically address… My arrows tend to hit the target at an angle instead of perpendicular, so I wonder if the rest could be causing it.

A rest is only one small piece of the bow, and has very little to do with controlling the oscillation of the arrow. I would personally need to watch you shoot and inspect your bow to provide any valued and specific advice. There are a ton of things that can cause your arrow to impact the target on an angle. The bow may need tuning, you may be plucking the string, the arrows may be too stiff or too flexible, and a lot of other things.

Quick Insight: “Bows only perform actions as directed by you; so make sure you have good form first.”

For more information on good form check out my website page The 10 Basic Steps of Archery and to understand controlling arrow movement such as oscillation, check-out the complete Arrow – The series.

Advertisements

Getting more Distance

Summer is here and with it the outdoor archery season. One of the biggest differences between indoor and outdoor archery, other than weather, is distance to the target.

Indoors everyone typically shoots at 18M however outdoors, depending on your age, division and category, you can shoot anywhere from 15M (Peewee) to 90M (Senior Male). As young archers get older and move up in division so do the distances they are asked to shoot. For instance, a pre-cub only needs to shoot maximum 30M in a target competition, however as a cub they need to shoot 50M. I remember trying to shoot Junior/Senior distances as a Cadet; 70 meters was a challenge. My sight was at the bottom and I was still not getting the distance I needed.

If you are struggling with a new distance you can make some equipment changes that can help such as ….

  • Heavier Limbs

Increasing draw weight will give you more force and therefore greater distance.

  • Move the entire sight down

Some sights, like the Cartel Mighty sight, you can move the entire T-bar lower. This allows you to lower the scope. Just remember to keep it out of the arrows flight.

  • Finger tab with a Shelf

Some finger tabs, like the Cartel Midas Finger Tab, have a shelf. If you adjust the shelf to be fully extended, you can lower your anchor point.

  • Spin vanes

For target archers you use synthetic feather fletchings, switching to plastic spin-wing vanes manufactured by Range-O-Matic can help a lot. Spin-wing vanes are lighter, offer less drag and are more forgiving as they help the arrows get into a tighter spin earlier.

Some times equipment changes are not an option because of cost, physical limitations and some times they only get you part way. Here are a couple of simple tricks that may help you reach those last couple of meters.

  • Wear a Mouth-Guard

Using a mouth-guard (or a piece Lego between your teeth) keeps your jaw open lowering your anchor point.

  • Mount your Sight Backwards

Mounting your sight backwards inside your bow, moves your sight marks lower and therefore changes the trajectory.

  • Use your Limbs as a Sight

In clout, a long distance (100M to 200M) sport you use your bottom limb as the sight. This can work for target archery as well. Pick a spot near the top of your lower limb to aim with for your possible distance.

If you have any tricks or tips to help gain more distance, I encourage you to share them.